بایگانی برچسب: TNT simulation in abaqus

In this tutorial, the Simulation CEL explosion inside the RC UHPC building in Abaqus-Damage investigation has been done The Ulta-High-Performance-Concrete(UPHC) building is modeled as a three-dimensional solid part. The reinforcements are modeled as wire part. The TNT is shpere part inside the Eulerian domain. You can see figures of the ...

In this tutorial the Simulation CFRP water storage tank under close air blast explosion in Abaqus has been investigaed. The CFRP tank is modeled as a three-dimensional shell part. The water is modeled as solid part and it’ll used as reference volume in load section to define the amount and ...

In this tutorial, the Simulation CEL explosion over the glass panel and damage investigation in Abaqus has been done. The glass, air, and TNT are modeled as three-dimensional parts. The Eulerian domain is modeled as a three-dimensional Eulerian part. You can see a figure of the assembled parts at below ...

Explosions, whether accidental or planned, can cause significant damage to the built infrastructure and result in fatalities to occupants of buildings in close proximity to the center of explosion. The increase in the number of terrorist attacks over the past few decades has led to growing concerns about the performance ...