Tag Archives: Simulation wood beam in abaqus

In this tutorial, the Simulation wood-steel plate connection with a nail under tension load in Abaqus has been investigated. The steel plate and nail are modeled as three-dimensional solid parts. The wooden plate also is a three-dimensional part. You can see a figure of the assembled parts below Cross-laminated timber ...

In this project, the Simulation bending test of an aluminium-timber composite beam with connections in Abaqus has been done. The timber wood slab is modeled as a three-dimensional solid part. The aluminium beam is modeled as a three-dimensional shell part. You can see a figure of the assembled parts below ...

In this tutorial, the Simulation compression test of a composite column(wood-uhpc-steel cover) in Abaqus has been investigated. The wood core and Ulta-High-Performance-Concrete parts are modeled as three-dimensional solid parts. The steel cover is modeled as a shell part. You can see a figure of the assembled parts below Wood columns ...

In this tutorial, Simulation low energy impact of a rigid hammer on the wood-cement-concrete panel in Abaqus has been investigated. The panel contians three layers, top layer is wood-cement part as a soild model, the second layer is normal strenght concrete as a solid part, and third layer is wood-cement ...

In this tutorial, the Simulation low energy impact on the multilayered wood panel in Abaqus-Damage investigation – has been done. The rigid ball is modeled as a three-dimensional shell part with a specific mass. Each wood panel is modeled as a three-dimensional solid part, and between the layers, the cohesive ...

In this tutorial, the Simulation dynamic four points bending of the timber wood beam reinfroced with CFRP rod and Gluein Abaqus  has been investigated. The wood beam is modeled as a three-dimensional solid part with two compression and tension sections. The adhesive and CFRP rod also is modeled as three-dimensional ...

In this tutorial the Simulation Wood-Glue-CFRP beam under dynamic four points bending test in Abaqus has been investigated. The wood beam are modeled as three dimensional solid part, the adhesive parts are modeled as three-dimensional solid parts, the CFRP also si solid and the the roller are modeled as rigid ...