In this tutorial, the ُSimulation of defected RC beam with sustainable aluminum boxes incorporating ultra-high-performance concrete in Abaqus has been investigated. The concrete beam, UHPC members, and aluminum boxes are modeled as three-dimensional solid parts. The steel reinforcements are modeled as wire parts. You can see figures of the assembled ...
ادامه نوشته »Simulation RC beam column joint reinforced with steel plates and rods under vertical load in abaqus
In this tutorial, the Simulation RC beam column joint reinforced with steel plates and rods under vertical load in abaqus has been investigated. The concrete beam-column is modeled as a three-dimensional solid part. The steel bar and strip are modeled as three-dimensional wire part. The steel plates and rods are ...
ادامه نوشته »Simulation RC beam under repeated impact of the rigid hammer in Abaqus
In this tutorial, the Simulation RC beam under the repeated impact of the rigid hammer in Abaqus has been investigated. The concrete beam is modeled as a three-dimensional solid part. The steel rebar and strips are modeled as three-dimensional wire parts. The rigid hammer is modeled as a three-dimensional rigid ...
ادامه نوشته »Simulation of low energy impact on the RC beam and residual displacement investigation in Abaqus
In this tutorial, the Simulation of low energy impact on the RC beam and residual displacement investigation in Abaqus has been done. The concrete beam is modeled as a three-dimensional solid part. The steel bars and strips are modeled as three-dimensional wire parts. The hammer is modeled as a rigid ...
ادامه نوشته »Simulation dynamic pullout of a steel plate from the RC beam in Abaqus
In this tutorial, the Simulation dynamic pullout of a steel plate from the RC beam in Abaqus has been investigated. The steel plate is modeled as a three-dimensional solid part. The concrete beam is modeled as a three-dimensional solid part. The bars and strips are modeled as three-dimensional wire parts. ...
ادامه نوشته »Simulation four points bending of an RC beam strengthened with CFRP sheet in Abaqus
In this tutorial, the simulation four points bending of an RC beam strengthened with CFRP sheet in Abaqus has been investigated. The concrete beam is modeled as a three-dimensional solid part. The strips and bars are modeled as three-dimensional wire part. The CFRP sheet is modeled as a three-dimensional shell ...
ادامه نوشته »Simulation CEL (Couple Eulerian Lagrangian) explosion over reinforced concrete in Abaqus
Explosions, whether accidental or planned, can cause significant damage to the built infrastructure and result in fatalities to occupants of buildings in close proximity to the center of explosion. The increase in the number of terrorist attacks over the past few decades has led to growing concerns about the performance ...
ادامه نوشته »