بایگانی برچسب: Finite element modeling of reinforced concrete

This example has done the finite element modeling of the pull-out test of precast wall panels connection in Abaqus. The two precast concrete walls are modeled as three-dimensional solid parts. The reinforcement steel bar and strips are modeled as wire parts. The steel bar as the connectors between two walls ...

In this tutorial, the Simulation load bearing capacity of a composite joint between a reinforced concrete column and a steel beam in Abaqus has been done. The concrete column is modeled as a three-dimensional solid part. The steel beam and column are modeled as three-dimensional solid parts. The steel bar ...

In this tutorial the explosion simulation near the reinforced concrete wall with green composite-SPH method- has been investigated. The TNT part is modeled as a three-dimensional solid part. The concrete wall or slab is modeled as three-dimensional solid part, the green composite part with eight layers is modeld as three-dimensional ...

In this tutorial, the Simulation four-point bending of the UHPC slab reinforced with steel bars and the GFRP sheet in Abaqus has been investigated. The UHP concrete slab is modeled as a three-dimensional solid part. The steel bars are modeled as three-dimensional wire parts. The GFRP sheet with eight layers ...

In this tutorial, finite element analysis of smooth particle hydrodynamics for application to projectile impact on cementitious material has been investigated. The performance of brittle, cementitious armor panels under high-rate impact is dependent on a wide range of variables including but not limited to projectile and target geometry, impact velocity, ...

In this tutorial Finite element modeling of reinforced concrete beams externally strengthened in flexure with side-bonded CFRP laminates in Abaqus has been done. The concrete beam and epoxy glue are modeled as three dimensional part,the CFRP is modeled as three dimensional shell part,the bar is modeled as three dimensional wire ...