بایگانی برچسب: Concrete damage simulation in abaqus

In this tutorial, the Simulation dynamic pullout of a steel plate from the RC beam in Abaqus has been investigated. The steel plate is modeled as a three-dimensional solid part. The concrete beam is modeled as a three-dimensional solid part. The bars and strips are modeled as three-dimensional wire parts. ...

In this tutorial, the Simulation pull-out process of the deformed steel bar from the concrete in Abaqus has been investigated. The goal of this simulation is the damage and failure zone analysis in the concrete slab. The concrete part is modeled as a three-dimensional solid part. The deformed steel bar ...

In this tutorial, the Simulation drilling hole process in the Abaqus by using a rigid drill tool has been studied.  Concrete drilling, or core drilling, is the process of drilling precise holes in concrete floors or walls, or in any other paved surfaces or structures. The concrete is modeled as a three-dimensional solid part. ...

In this tutorial, the Simulation rigid impact on the ultra-high performance fiber reinforced concrete slab in Abaqus has been investigated. UHP-FRC is a new class of concrete that has been developed to give a significantly higher material performance in comparison to its concrete counterparts. UHP-FRC exhibits superior mechanical characteristics, including ...

In this tutorial, the Simulation flexural behavior of reinforced concrete beams strengthened with ultra-high performance concrete in Abaqus has been done. Strengthening of concrete structure has become very important not only for deteriorating concrete structures, but also for strengthening new concrete structural members so that they perform much better under ...

In this tutorial, the Simulation of ECC/Concrete Composite Beam-Column Joints under axial loading in Abaqus has been investigated. For conventional reinforced concrete frame structures, the seismic performance mostly depends on the deformation ability of key components such as beams, columns and their joint zones. Under earthquake actions, these members are ...

In this tutorial, the simulation dynamic bending behavior of the concrete pipe strengthening with epoxy lining in Abaqus has been investigated. Pipelines are an essential component of a city’s infrastructure. Compared to other structures, buried infrastructures have a higher risk of deterioration due to the particularly harsh surrounding environment. Deterioration ...

In this tutorial, the Simulation blast explosion over the composite column in Abaqus- Damage investigation – has been studied. The model contains three deformable parts. The outer steel box as a cover is modeled as a three-dimensional shell, the middle concrete is modeled as a three-dimensional solid part and the ...

In this tutorial, finite element analysis of smooth particle hydrodynamics for application to projectile impact on cementitious material has been investigated. The performance of brittle, cementitious armor panels under high-rate impact is dependent on a wide range of variables including but not limited to projectile and target geometry, impact velocity, ...

In this tutorial Simulation underwater explosion near a concrete dam by using the CEL method in Abaqus has been investigated. The dam is modeled as a three dimensional part, The TNT, water, and air are modeled as the Eulerian part. You can see a figure of the assembled parts at ...

Explosions, whether accidental or planned, can cause significant damage to the built infrastructure and result in fatalities to occupants of buildings in close proximity to the center of explosion. The increase in the number of terrorist attacks over the past few decades has led to growing concerns about the performance ...