بایگانی برچسب: abaqus impact simulation

In this tutorial the Simulation low energy impact on the concrete slab with pre tensioned bars reinforced with GFRP in Abaqus has been studeid. Concrete is modeled as a three-dimensional solid part. The GFRP part is model as plannar shell part. The steel basrs are modeled as three-dimensional wire part ...

In this tutorial, the Simulation of steel projectile impact to the Reinforced-Ultra-High-Performance Concrete- Damage investigation has been investigated. The Ultra-High-Performance Concrete is modeled as the three-dimensional solid part, the embedded beam parts are modeled as a three-dimensional wire part, and finally, the steel projectile is modeled as a solid part. ...

In this package, the high and low-velocity impacts are investigated through 40 step-by-step tutorials for more than 20 hours. Through those 40 separated simulations, all aspects of the impact and collision are studied. Each tutorial contains cae, inp, step-by-step English video, and papers, also some of them have codes. Impact ...

In this tutorial, the Simulation of low energy impact on the RC beam and residual displacement investigation in Abaqus has been done. The concrete beam is modeled as a three-dimensional solid part. The steel bars and strips are modeled as three-dimensional wire parts. The hammer is modeled as a rigid ...

In this tutorial, the Simulation rigid ball impact on the steel pipe with and without the CFRP reinfocement layers in Abaqus  has been investigated. The steel pipe is modeled as a three-dimensional shell part. The CFRP pipe is modeled as three-dimensional shell part and conventional shell section with eight layers ...

In this tutorial, the Simulation low velocity impact on the composite panel(three glass layers+two epoxy layers) in Abaqus  has been investigated. The three glass layers are modeled as three-dimensional solid parts. The two glue or epoxy layers are modeled as three-dimensional solid part. The rigid projectile and supporter are modeled ...

In this tutorial Prediction model of depth of penetration for alumina ceramics under garnet impact in Abaqus has been studied .The target and projectile were modeled as three dimensional parts .The JH-2 constitutive model was proposed to describe the response of ceramic materials to large strain rate. The JH-2 constitutive model ...

In this tutorial Simulation cold spray process by using SPH method in Abaqus has been investigated. In Cold Spray, powder particles (typically 10 to 40 µm) are accelerated to very high velocities (200 to 1200 m.s-1) by a supersonic compressed gas jet at temperatures below their melting point. Upon impact with the ...

The study of interaction between two impacting bodies, known as impact dynamics or terminal ballistics has many crucial applications. Bullet impact on armor, occupant and pedestrian safety during automobile accidents, tool drop on aircraft wing, are few examples where impact dynamics plays an important role. An in-depth understanding of deformation ...

With the growing use of composites in military, air vehicles and naval structures, sporting goods and the power industry, the comprehension of impact mechanism and dynamic behavior is critical to composite designers and end users. A wealth of knowledge has been published on dynamic impact response of composite materials and ...

Sandwich panels are widely used in lightweight construction especially in aerospace industries because of their high specific strengths and stiffnesses. In the service life of a sandwich panel, impacts are expected to arise from a variety of causes. Debris may be propelled at high velocities from the runway during aircraft ...