بایگانی برچسب: abaqus fracture simulation

In this tutorial Finite element simulation of air blast explosion over the glass in Abaqus-Damage analysis- has been investigated.The glass and frame are modeled as a three dimensional part.You can see a figure of the assembled parts at below Elastic plastic material with Johnson-Cook damage criterion is used to model ...

In this tutorial dynamic simulation of tensile test of a steel piece under axial deformation in Abaqus has been investigated. A three dimensional part like below figure is used to model steel geometry To model failure behavior of the steel piece shear and ductile damage with evolution, isotropic plasticity with ...

In this tutorial Simulation of p-section concrete beams under contact explosion(CEL) conditions in Abaqus has been studied. Reinforced concrete bridges are the most common type of bridges and have a simple structure, low cost and long durability. Among these bridges, reinforced concrete bridges composed of p-section bridge components are among the ...

In this tutorial Prediction model of depth of penetration for alumina ceramics under garnet impact in Abaqus has been studied .The target and projectile were modeled as three dimensional parts .The JH-2 constitutive model was proposed to describe the response of ceramic materials to large strain rate. The JH-2 constitutive model ...

With the growing use of composites in military, air vehicles and naval structures, sporting goods and the power industry, the comprehension of impact mechanism and dynamic behavior is critical to composite designers and end users. A wealth of knowledge has been published on dynamic impact response of composite materials and ...

In this tutorial Simulation fatigue phenomenon of the steel plate in Abaqus by using direct cyclic step has been investigated.Two dimensional part for steel and wire part to define initial crack length has been used . Elastic material couple with traction separation law to consider the fracture and crack growth in ...