بایگانی برچسب: Abaqus fire and failure analysis

In this tutorial, the Fire analysis of a Steel-Timber composite beam in Abaqus has been done. Both steel and timber wood beams are modeled as three-dimensional solid parts. You can see a figure of the assembled parts below The combination of timber and steel in a single-beam cross-section can result ...

In this tutorial, the Simulation hollow-core slab under fire conditions and four-point bending in Abaqus has been investigated. Precast/prestressed concrete hollow core (PCHC) slabs with a reduction in self-weight due to longitudinal voids, and without shear reinforcement due to the extrusion method are most susceptible to shear failure. When subjected ...

In this tutorial, the Simulation fire analysis of a steel joint with bolt connectors in Abaqus has been investigated. The two steel plates are modeled as three-dimensional solid parts. The bolts are modeled as three-dimensional parts. You can see a figure of the assembled parts below Steel has been at ...

In this tutorial, the fire analysis of a composite beam (RC concrete slab+ steel beam) under bending load in Abaqus has been done. The concrete slab is modeled as a three-dimensional solid part. The steel reinforcements are modeled as wire parts. The steel beam is modeled as a three-dimensional solid ...

In this tutorial, the Fire simulation in Abaqus-Thermal and Structural analysis of a steel frame has been investigated. The steel beam is modeled as an I-shape three-dimensional part. The two box columns are modeled as three-dimensional parts. You can see a figure of the assembled parts below Steel has been ...

In this tutorial, the Simulation of RC Beams during Fire Events Using a Fully Coupled thermal stress Analysis in Abaqus has been studied. The concrete beam is modeled as a three-dimensional solid part. The steel reinforcements are modeled as wire parts. You can see a figure of the assembled parts ...

In this tutorial, the Simulation full three Dimensional fire analysis of a Reinforced concrete beam in Abaqus-Sequential Coupling Technique- has been investigated. The concrete beam is modeled as a three-dimensional solid part,. The longitudal bar and strips are modeled as three-dimensional solid part. You can see a figure of the ...

In this tutorial, the Simulation steel beam under fire and mechanical load condition in Abaqus  has been investigated. The steel beam is modeled as a three-dimensional solid part and also it can be modeled as a shell part. You can see a figure of the part with fire and mechanical ...