بایگانی برچسب: abaqus concrete failure simulation

In this tutorial, the Simulation of rigid body impact on the interior voided RC slab in Abaqus has been investigated. The RC voided slab is modeled as a three-dimensional solid part. The steel bars are modeled as three-dimensional wire parts. The rigid impactor is modeled as a three-dimensional shell part. ...

In this tutorial, the Simulation circular concrete-encased concrete-filled steel tube (CFST) stub columns subjected to axial compression in Abaqus has been investigated. Compared with CFST columns, the advantages of concrete-encased CFST columns include higher stiffness, convenient connection with RC beams, and higher resistance to fire and corrosion. In addition, a ...

In this tutorial, numerical simulation of blast resistance of RC slab strengthened with AFRP in Abaqus-Damage investigation- has been studied. The concrete slab is modeled as a three-dimensional solid part, the AFRP is modeled as four layers composite with shell part and the embedded beam inside the concrete host is ...

In this tutorial Simulation of concrete cover separation failure in FRP plated RC beam in Abaqus has been studied.The infrastructures in developed countries are aging and in addition changes in their using purposes, increase of load level, constructional faults and damages or deterioration demand adequate maintenance and the upgrading of ...

In this tutorial Simulation low velocity impact on reinforced concrete beam in Abaqus-Damage investigation has been studied .Reinforced concrete (RC) structures have been widely used for centuries but the understanding of the impact behavior of these structures against impact loads is still limited. Several design codes based on an equivalent ...

In this tutorial Simulation couple Eulerian Lagrangian explosion over concrete column with foundation in Abaqus has been studied.The concrete column and foundation are modeled as three dimensional part. The eulerian domain is modeled as eulerian part and TNT as sphere in it near the column. The beams as reinforcement are ...

In this tutorial Simulation dynamic tensile test of a concrete piece in Abaqus has been studied. The concrete part is modeled as three dimensional part. Normally concrete damage plasticity is used to model compression and tensile damage on the concrete pieces, during static or dynamic analysis. In this tutorial dynamic ...

In this tutorial Simulation concrete slab cutting by using a rigid cutter in Abaqus has been investigated.Concrete cutting is a process of controlled sawing, drilling and removal of concrete performed by skilled operators using special saws that use diamond impregnated blades. Unlike the old-fashioned dusty jack hammer method, modern concrete ...