بایگانی برچسب: abaqus composite beam simulation

In this tutorial, the Simulation bending test of the steel-concrete composite beam in SRC structures considering bond-slip behavior in Abaqus has been investigated. The steel-concrete composite beam is modeled as a three-dimensional solid part. The steel reinforcements are modeled as the wire parts. You can see a figure of the ...

In this tutorial, the Simulation cyclic loading of a steel beam-column joint with welded steel angle and stiffeners in Abaqus. Box column, steel beam angles, and stiffeners are modeled as the three-dimensional solid part. If a structural steel member is subjected to a cyclically varying load of sufficient amplitude it ...

In this example, the Simulation air blast load over a composite beam(Wood+Aluminum) in Abaqus has been investigated. The wood slab is modeled as a  three-dimensional solid part with tension and compression zones. The aluminum beam is modeled as a three-dimensional shell part. You can see a figure of the assembled ...

In this tutorial, the Simulation bending test of a steel-concrete(foamed concrete) composite beam in Abaqus  has been studied. The foamed concrete ( containing partial cement replacement) is modeled as a three-dimensional solid part. The steel beam is modeled as a three-dimensional shell part. The steel reinforcement is modeled as a ...

In this tutorial, the Simulation Composite beam(Concrete and steel beam) under fire condition in Abaqus-Thermal and Stress analysis- has been studied. The concrete and steel beam are modeled as three-dimensional solid parts. You can see a figure of the assembled parts below Reinforced concrete (RC) structural members, when exposed to ...

In this tutorial, Simulation of Stud Connected Steel-Concrete Composite Girders Subjected to four-point bending in Abaqus has been studied. The performance of steel-concrete composite (SCC) girders for static and dynamic loads depends significantly on the force transfer mechanism at the interface between steel beam and concrete. Stud connected SCC girders consist ...

In this tutorial, the simulation composite column(steel beam and concrete)under cyclic loading in Abaqus has been studied. The steel beam and the concrete parts are modeled as three-dimensional solid parts. You can see a figure of the assembled parts at below The steel material is used for the steel beam ...

In this tutorial numerical simulation of steel–concrete joints and composite beams has been studied.The model contains concrete slab,steel sheet,steel beams and rigid bodies. You can see a figure of the assembled parts at below Concrete Damage Plasticity(CPD) material model for concrete and elastic plastic model for steel has been used. ...