بایگانی برچسب: Abaqus CFRP failure analysis

Introduction to Numerical Study on CFRP-Lined Concrete Cylinder Pipe (CCP) Under Internal Explosion Concrete Cylinder Pipes (CCPs) are widely used in water transmission systems due to their high load-bearing capacity and durability. However, they are vulnerable to internal explosions caused by accidental gas ignition or deliberate attacks, leading to catastrophic ...

Introduction to Strengthening Corroded Steel Columns with CFRP Corrosion in steel columns is a major concern in structural engineering, leading to reduced load-bearing capacity, stiffness, and overall structural integrity. Traditional repair methods, such as steel plate bonding or section enlargement, can be costly, labor-intensive, and sometimes impractical. Carbon Fiber Reinforced Polymer ...

Introduction to Composite Materials Composite materials are engineered materials made from two or more constituent materials with significantly different physical or chemical properties. When combined, these materials produce a material with characteristics different from the individual components. The primary constituents of composites are Matrix: The continuous phase that binds the ...

In this tutorial, the crushing analysis of a foam-filled aluminum/CFRP hybrid tube against transverse impact in Abaqus was done. The aluminum tube, CFRP, and aluminum foam are modeled as three-dimensional parts. You can see a figure of the assembled parts below Thin-walled structures made of conventional metals, such as aluminum ...

In this tutorial, the Simulation of high-velocity impact on CFRP-Aluminum foam-Aluminum honeycomb-CFRP panel in Abaqus has been studied. The CFRP parts are modeled as three-dimensional parts with sixteen layers. The aluminum foam is modeled as a three-dimensional solid part. The aluminum honeycomb is modeled as a shell part. You can ...

Simulation air blast explosion over a composite panel(CFRP-Ceramic-GFPP) in Abaqus has been investigated in this tutorial. The CFRP and Glass fiber Polypropylene are modeled as shell parts with some layers. The ceramic core is modeled as a solid part. You can see a figure of the assembled parts below The ...

Four-point bending test of an aluminum pipe reinforced with four CFRP layers in Abaqus has been modeled in this tutorial. The aluminum pipe is modeled as a solid part, the CFRP pipes are modeled as four seperate shell parts. Cohesive interaction property is considered among all layers. You can see ...